SPECIFICATIONS

Brand Name: LZHZXY
Type: Vacuum Forming Machine
Origin: Mainland China
Model Number: JT-18
Product number: FL0034
Power: 1000W
Power supply voltage: 220V/50Hz+/-10%/110V/60Hz+/-10%

Dental Vacuum Former Forming and Molding Machine 220V/110V 1000W
dental equipment

Picture showing : 

Product details:

Features : 
1,bleaching braces forming and fabrication ;
2, maintaining orthodontic appliances , dental splint molding and production ;
3, periodontal disease, fluoride treatments tray molding and production ;
4,temporary , permanent denture base , mouthpiece care molding and production ;

Instrustions:
1, first pull rod , and then plaster model trimmed in a vacuum online .
2, the film on the mezzanine , tighten the screw button.
3, open the heating switch observed softness film until the film is heated evenly.
4 , the lever depressed after heating the soft film covering the plaster model
5, turn off the heating switch , turn on the vacuum switch , 
vacuum for 10-15 seconds , braces can be formed.
6 , the first film outside the pen to draw marked by gingival margin .
7 After cooling the film with scissors or grinding to remove excess film by Mark completed braces 
Details :

   Remain transparent orthodontic appliances or without clasp , beautiful, wear comfortable, remain stable, 
and simple production by the majority of dentists welcome, 
Different from the first use of the tool : plastic sheet vacuum forming machines and special . Hard plastic 
sheet used in orthodontics , the choice of 0.8mm ~ 1.5mm.
1,get an press mould
2, filling gypsum, plaster casts upon dry dressing models , 
remove the bottom part of the palate and tongue should be the best it into a "U" .
3, Place the slices on a molding machine , clamping , jumping heated place. 
Then take the model into the vacuum forming machine vacuum suction machine .
4, slices of hard vacuum machine heater heating , let depression about 2 cm . The deeper the recess , 
the holder will be thinner . 
Put it down on the model until it is fully in place.
5, vacuum suction machine for 15-20 seconds to ensure molding. 
Remove the heater , which will be cool to remove it die .
6, Use scissors to trim off the excess , or burs directly along the gingival margin under 2 ~ 3mm under 
its grinding, trimming the edges , reserves the gingival margin 0.5 mm
7, braces after pruning is completed, the braces placed on the model again to check fit . Such an 
orthodontic retainer will be made , and if that edge is not close together,